The PC shifter (PC only) has H / SEQ modes and includes the chosen mount.
The shifter includes:
-Selected mount option
-Top plate "7 + R" or "6 + R"
-Threaded long knob "Sequential"
-Threaded short knob "H-pattern"
-Adapter for commercial knobs*
-USB cable lenght 180 cm. It can be replaced by any type B USB cable on the market up to 3m.
The RAW top plate has a very slightly rough finish. It may be perfectly valid without vinyl, but it has not a bright or a perfectly pulished surface.
You can customize the shifter with many options here.
NOTE: The shifter has both H and Sequential modes without the need of the SEQ plate, it is optional.
* Valid for knobs with thread M17x1.5
You must select the necessary mounting option according to your needs. These are the options:
TABLE: mount for tables or similar without holes. Maximum thickness 55mm (2.2in). This mount CANNOT be used on thicker tables.
G25/27/29: support for cockpits that include holes for "Logitech G25 / G27 / G29" shifters.
TH8: support for cockpits that include holes for "Thrusmaster TH8A and TH8RS" shifters.
L PLATE: L PLATE for anchoring screwed into custom cockpits or profiled aluminum cockpits.
ZALEM: Ready for "Zalem" cockpits or clones. Includes a 25x25 square tube, entering in a 30x30 tube.
FANATEC: Ready for some older Fanatec steering wheels, with two 13mm bars (not included).
BOTTOM MOUNT: ready for a bottom mounting. It has 4 M4 threaded holes in the same position as the "Fanatec SQ V1.5" shifter (THIS SUPPORT IS STILL IN PROCESS, CONSULT FOR BETTER INFORMATION and / or SUGGESTIONS FOR IMPROVEMENTS)