The PC shifter (PC only) has H / SEQ modes and includes the chosen mount.
The shifter includes:
-Selected mount option SUGGESTIONS
-Top plate "7 + R" or "6 + R"
-Threaded long knob "Sequential" type
-Threaded short knob "H-pattern" type
-Adapter for commercial knobs*
-USB cable lenght 180 cm. It can be replaced by any type B USB cable on the market up to 5m.
-2mm - 2.5mm - 3mm Allen keys for various configuration and/or mounting changes.
The RAW top plate has a very slightly rough finish. It may be perfectly valid without vinyl, but it has not a bright or a perfectly pulished surface.
You can customize the shifter with many options here.
NOTE: The shifter has both H and Sequential modes without the need of the SEQ plate, it is optional.
* Valid for knobs with thread M17x1.5
You must select the necessary mounting option according to your needs. These are the options:
STANDARD COCKPITS: mount for cockpits that include holes for "Logitech G25 / G27 / G29" or "Thrusmaster TH8A and TH8RS" shifters. This mount allows the shifter to be raised or lowered by 50mm.
TABLE: mount for tables or similar without holes. Maximum thickness 55mm (2.2in). This mount CANNOT be used on thicker tables. This mount allows the shifter to be raised or lowered by 25mm.
BOTTOM MOUNT: Ready for a bottom mounting. It has four M6 threaded holes in the same position as the "Fanatec SQ V1.5" shifter (M6x20 screws included) and also has two holes for M8 bolts front and behind for mounting the shifter into custom cockpits or profiled aluminum cockpits (screws not included). This mount is bolted to the shifter and only the NEWT2 version is compatible.
LATERAL MOUNT (IMAGES IN PROCESS): ready for a lateral mounting, both in a cockpit with a profiled tube, and in a cockpit made by hand. IT CAN ONLY BE SCREWED INTO PROFILED TUBES WITH TWO SLOTS. It also allows you to add one of our mounts at 90º (second mount not included). If you have any doubt ask us here.
L PLATE / CUSTOM COCKPITS: this plate has several holes for many different attachments (very useful in home made cockpits). Check here holes measures. It can also be used for cockpits with profiled tube. The mount does not include bolts for the cockpit. Not suitable for cockpits with bases prepared for commercial shifters because the holes will not be compatible. This mount allows the shifter to be raised or lowered +/- 50mm but it does not allow lateral mounting. Consult doubts.
"FANATEC OLD": Ready for some older Fanatec steering wheels, with two 13mm bars (not included).
LOOK AT THIS IF YOU NEED ONLY THE SHIFTER'S BODY